CNC PP60c questions

[aresfab]

Now see that is what I thought but this is what there add says.

- Built in CNC socket with OK to move, arc voltage divider, torch height controller etc.

I just read built in thc. Now I need to figure out how to wire the thing.

Thanks

[todmorg]

Now see that is what I thought but this is what there add says.

- Built in CNC socket with OK to move, arc voltage divider, torch height controller etc.

I just read built in thc. Now I need to figure out how to wire the thing.

Thanks

I've built a couple THC's from scratch, let me know if I can help you out.

Mine interface to Mach3.

[SeanMurphy265]

I've built a couple THC's from scratch, let me know if I can help you out.

Mine interface to Mach3.

I'm looking for a THC to run with my Probotix system. How much would you charge to build one?

[Rodsmachineshop]

Attachment 6168 diagram i found on the site my plasma has this plug on the back of unit everlast 50p

[aresfab]

I've built a couple THC's from scratch, let me know if I can help you out.

Mine interface to Mach3.

Yes I would like any help.

[SeanMurphy265]

Have you purchased a Torch Height Controller?

[SeanMurphy265]

Here is a link with a guy using Everlast PP50, Tom from CandCNC.com has some insights that will help.
http://www.cnczone.com/forums/plasma...t_4_0_a-5.html

[Rodsmachineshop]

Was sitting and was thinking a simple cheaper way to make a cnc set with half the materials. Why not just a single beam rail system that how some of the big cnc machine builder make them

[SeanMurphy265]

How about this one!