PP 256 S75 Plasma torch red wire connection

[Schuh]

I have indeed read the manual several times. Referring to page 13 it does not specifically describe what to set the preflow or postflow to nor is it repeated elsewhere. Perhaps it may be obvious to some but not to me. I would suggest that maybe on the next manual revision you clearly state on page 13 that you set all the torch controls (green knobs) to zero except for postflow. Judging by previous blogs on plasma problems changing the manual may save others from asking the same dumb questions.

Also add the red wire off the S75 torch to the Pilot Arc Post which is missing in the diagram.

This manual is a great improvement over the Chinese edition but a few more improvements would go a long to reducing your constant need to assist customers with machine setup and adjustments.

[zoama]

I have indeed read the manual several times. Referring to page 13 it does not specifically describe what to set the preflow or postflow to nor is it repeated elsewhere. Perhaps it may be obvious to some but not to me. I would suggest that maybe on the next manual revision you clearly state on page 13 that you set all the torch controls (green knobs) to zero except for postflow. Judging by previous blogs on plasma problems changing the manual may save others from asking the same dumb questions.

Also add the red wire off the S75 torch to the Pilot Arc Post which is missing in the diagram.

This manual is a great improvement over the Chinese edition but a few more improvements would go a long to reducing your constant need to assist customers with machine setup and adjustments.

Preflow to 0, Post flow to 10 or more for long cuts.