Cutting Expanded Sheet Metal

[xtreme cartz]

Maybe I set the PSI on the plamsa too low, 60-65 PSI? I can cut continuously and the gauge on the cutter never falls below 60.

[undercut]

Maybe I set the PSI on the plamsa too low, 60-65 PSI? I can cut continuously and the gauge on the cutter never falls below 60.

Every diagnostic test should begin with removing the obvious. It's a pain but it might help move the process along. I know you said the pilot arc seems to be working but we need to ensure it is working as it should. You were going to post a video?