Post your best aluminum welds!

[2rods]

Thanks.

Dynasty 350
250 hz-300 hz ac freq depending on material thickness and joint design
material is 5052 varying thickness
filler is 5356
EN to EP Amperage Ratio Approx 1.5:1
balance @ 70% EN
wave shape - advanced squarewave

Didn't think it was an Everlast.

[sschefer]

Nice to see someone knows the benefits of a shiny clean welding table.. Makes a huge difference working on non ferrous stuff. I wipe mine down with Acetone to keep the oils and dirt from transferreing to the work piece. Sure cuts down on the head scratching.

[Zoomie]

Wow! Some of you guys are freakin talented. Beautiful welding Tony, Jakeru, cdale! I think some of you guys could weld with an 110v extension cord with the end wacked off and a darn coat hanger! Again, awesome.

[Shield Arc]

WOW! After seeing TonyR85 welds I'm ashamed to even post my welds. But you guys can at least get a good laugh.


Remember I'm a structural hand, nowhere near a Tig weldor!

[Rivets]

Hey TonyR85,

Talk about beautiful welds !
Any chance you could borrow a PP256 and duplicate them ?

Would sure make me feel super good for having ordered one.

Cheers,
Rivets

[91TSiGuy]

Not my best aluminum welds I've done in a while (or best pics for that matter--cell phone) but these were done with the Everlast PM205, ~8 or 9 on the pedal, 1/8" filler. I've been stuck wrenching more than I have been welding at my new job where as the last one was full on welding/manufacturing.

Attachment 1399Attachment 1400

[jameswswanson]

Not my best aluminum welds I've done in a while (or best pics for that matter--cell phone) but these were done with the Everlast PM205, ~8 or 9 on the pedal, 1/8" filler. I've been stuck wrenching more than I have been welding at my new job where as the last one was full on welding/manufacturing.

Attachment 1399Attachment 1400

Those look petty good to me, nice job!