Wrenchtamer....
I think you need to go back and read your thread. We did give you answers. In fact I gave you some settings to test. You never got back to us or contacted us back directly about this. I gave you settings to try on frequency and balance control.
IF you had told us anything about being able to test certain aspects, Mike could have told you what to test. MOST people are NOT technically competent. If you have a scope and need to know where to test the unit, then I'd say you fall into that category.
I did recommend you check the videos so you could see one welding correctly....You apparently abandoned the thread. You posted no further information or pictures or questions. You can tell a lot from pictures.
We have helped you with confirmed operator error issues as well. So its hard for us to know what level you are at in your welding when these things are basic and our manual states them online.
I have been and will continue be glad to help you but your post isn't fair nor accurate about the nature of things.
So people can see what I am talking about I am posting a link to your posts about it here:
http://www.everlastgenerators.com/fo...-question.html
http://www.everlastgenerators.com/fo...-pm-256-a.html
http://www.everlastgenerators.com/fo...-aluminum.html
Reply With Quote