cutting holes in flat stock

[jpecor]

need help with cutting holes in flat stock. No info on gouging tips or anything else. Any HELP!!!!!

jpecor

[everlast_support]

Here is a good article on plasma cutting.

http://www.off-road.com/trucks4x4/artic ... ?id=325779

[jpecor]

Thanks..good artical. But where can I buy the tips, the guides, and standoffs for my Everlast unit????

[everlast_support]

You can call Everlast for the consumables.

Or post here or on weldingweb.com, a project you have done with pictures and get a free set.

[presure2]

You can call Everlast for the consumables.

Or post here or on weldingweb.com, a project you have done with pictures and get a free set.

does this offer still stand?
im an internet picture whore. haha

[dgarnier]

Any more info on this? once my pt250ex shows up I have quite a few projects lined up, and rather then buying all the sizes of collects I could post up some pics

[shawn]

ya does that offer still stand? i'm all about some free consumables and have pictures of bumpers, axles, and carts i've built using everlast units