Share
Results 1 to 8 of 8

Thread: Problems with my PTM80 Machine Torch

Hybrid View

Rodzilla Problems with my PTM80... 05-11-2020, 11:27 PM
Rodzilla Well talking to others I did... 05-12-2020, 12:35 AM
performance It could. But torch stand... 05-13-2020, 08:32 PM
Rodzilla Thanks for replying. Air is... 05-14-2020, 03:48 PM
performance Where is your swirl ring? 05-15-2020, 04:12 AM
Rodzilla Not on during these pics. But... 05-15-2020, 04:24 PM
performance It goes back to low air... 05-15-2020, 05:54 PM
Rodzilla I'd have it set at 80, so... 05-16-2020, 11:16 PM
Previous Post Previous Post   Next Post Next Post
  1. 05-15-2020, 04:24 PM #1
    Rodzilla is offline New Member
    Join Date
    Sep 2015
    Posts
    18

    Default

    Not on during these pics. But it was.
    Reply With Quote Reply With Quote
  2. 05-15-2020, 05:54 PM #2
    performance's Avatar
    performance is offline Everlast Sales and Support Team
    Join Date
    Jul 2009
    Posts
    5,371
    Blog Entries
    1

    Default

    It goes back to low air pressure. How much pressure were you running while cutting?
    Mark
    performance@everlastwelders.com
    www.everlastgenerators.com
    www.everlastwelders.com
    877-755-9353 x204
    M-F 9am - 5pm EST
    Reply With Quote Reply With Quote
  3. 05-16-2020, 11:16 PM #3
    Rodzilla is offline New Member
    Join Date
    Sep 2015
    Posts
    18

    Default

    I'd have it set at 80, so once it was running it would drop to 72-74.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules