I have a 60s that I bought about a month ago, really just started using it, the pilot arc quit working, replaced the fuse, checked the ground and cable, get ok to cut light, get solenoid and air, get not pilot or arc, only get arc if I scratch start and then it is very weak or will not cut. At this point the trouble shooting guide says contact Everlast.. Im sure someone knows whats going on. Did this thing fry a board already? I have an air dryer on my compressor and the one that comes with the machien on the back and regulator. I also have sent in an email for support. Bought the machine straight from Everlast.
Thanks
Chuck Carmin
906-420-3874