Share
Results 1 to 2 of 2

Thread: `Cause They don't Sell them at the Auto Parts Store

  1. #1
    Join Date
    Aug 2014
    Location
    Westerville, Ohio
    Posts
    72

    Default `Cause They don't Sell them at the Auto Parts Store

    The vehicle is a 2004 Chevy Cavalier. I've owned it since 2006. The exhaust predates my ownership.

    A steel rod welded to the exhaust pipe as a support was so corroded, it came off in my hand as I was working to replace the corroded steel hydraulic lines to the rear brakes.

    A check of Advance Auto Parts and AutoZone didn't produce any ready-made bolt-on replacements. So, it's roll your own.

    Photo of the parts on the driveway are as follows:

    First up from the bottom is the broken off welded-on support rod.

    Second up from the bottom are two 2" exhaust clamp bodies with a 5/16" rod welded between them. The bend in the rod was courtesy of the vice and a ball peen hammer.

    Third and forth up from the bottom of the photo are two halves of a 2" diameter section of exhaust cheater pipe. The pipe was cut to 4" in length then split in two halves.

    Why the two halves?

    Since this is going on an old exhaust pipe, I feared the clamps would crush the rust-weakened metal. The sleeves will provide a solid foundation for the clamps and distribute the crush forces over a greater surface area on the rusty pipe.

    The most difficult part of the effort was grinding away the remains of the original welded-on rod. A slip with the grinder would have damaged the already-corroded exhaust. This little stop-gap measure is in order to try and put off the expense of a new exhaust as long as practically possible.


    Click image for larger version. 

Name:	6260.jpg 
Views:	263 
Size:	132.7 KB 
ID:	13794
    Click image for larger version. 

Name:	6265.jpg 
Views:	252 
Size:	114.8 KB 
ID:	13792
    Click image for larger version. 

Name:	6264.jpg 
Views:	236 
Size:	110.6 KB 
ID:	13793
    Last edited by fyidiy; 08-26-2018 at 02:09 AM.

  2. #2

    Default

    Good job. You can also buy straight and mandrel bent pipe to make your own exhaust when that one is done. Maybe $120 for everything, you just have to shop around.
    2013 250EX : SSC Pedal : I-MIG 250P 20' Profax gun : Power Plasma 60 p80 torch : 3M Speedglas 9100XX : Evolution Rage 3 DB cold saw

Similar Threads

  1. I-mig 140E trade? or sell
    By pavetim in forum Buy, Sale or Trade
    Replies: 5
    Last Post: 03-30-2016, 09:15 PM
  2. Replies: 2
    Last Post: 04-08-2011, 06:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •