Can you spare a ...

[Rambozo]

Shook the rust off and actually did a little welding today. Made a couple of small parts for some UTVs. Cut up some .095" wall square tube and some .25" plate.



Clamped up to tack with Fireball mini mega square. I'm finding these things pretty handy. They get into a lot of places where other clamping systems just don't fit. Still waiting to assemble new welding table, so I need something to hold things square on the portable table.



Left a pretty good gap so I could sink the welds near flush on the sides and have most of the reinforcement on the inside of the tubing.That way just an optional kiss with a flap disc and ready to paint. Add a filet on the inside and round over the outside corner joint. Weld out the plate, too.



A little paint.



And time to install.





Inspector came over to check. Made one in 1.25" and one in 2" for the different front receivers. Still have one more to do, when that unit is around. Kubota changes things every few years, so none of these interchange. At least these two share a wheel hub pattern. The newest one changes that, too.



It sure would be nice to have the clickable thumbnail system working again. It is a royal PITA to work with photos the way things are right now.

[christian]

Hey,

Way cool, dude!

Interesting squares, as those little removable tabs are neat, too.

[christian]

Yeah,

It just occured to me that your photos post as open images in this thread.

Lately, my pic uploads to a thread have been unopened images, that took a click and a new window to see each one.

Let me use your thread, if you don't mind, to check that myself.



Yeah, I'm still not getting open images to a thread somehow.

[zoama]

Yeah,

It just occured to me that your photos post as open images in this thread.

Lately, my pic uploads to a thread have been unopened images, that took a click and a new window to see each one.

Let me use your thread, if you don't mind, to check that myself.



Yeah, I'm still not getting open images to a thread somehow.

You have to upload and then manage attachments under "go advanced" then select and drag images to insert on line 1,2,3 etc.

[christian]

Hey,

Thanks for that!

[performance]

Very good craftsmanship. One tool I don't have is a good tubing bender. I have a pipe bender, but that kind of flat spots/kinks the tubing if it is too light. It would cut down on mitering a good bit.

[Rambozo]

You have to upload and then manage attachments under "go advanced" then select and drag images to insert on line 1,2,3 etc.

I remember how nice it was when you could just have nice inline thumbnails that linked to the full size images. Those were the days.




"Uploads not utilized within one hour will be deleted" I wish that were true, too.

[oleblu72]

What do you make your cuts with Rambozo they look nice & straight.

Mark