Share
Results 1 to 2 of 2

Thread: Using generator with TIG welder

  1. Default Using generator with TIG welder

    I have a Generac 7500e generator it runs at 7500 watts and 9375 starting watts. It has a 30 amp plug that is rated at 120/240 volts. I have a powerpro 205 multi process Everlast welder. I have a feeling this generator is too small for that machine but what machine will be capable of running of it? what I ultimately like to have is a TIG welder that I can run off this generator so I can do mobile jobs.

    1. Is this generator too small for my current welder ?
    2. What TIG welder could I run off this generator from Everlast?

  2. #2
    Join Date
    May 2012
    Location
    Disneyland
    Posts
    2,662

    Default

    Should be enough power, just not sure how clean it is. It can be hard to get the THD specs from generator manufacturers, and inverter welders need cleaner power than the old transformer type.
    Long arc, short arc, heliarc and in-the-dark!

Similar Threads

  1. Using a welder with a generator
    By Woody in forum General Welder Questions
    Replies: 10
    Last Post: 06-23-2023, 03:43 PM
  2. Mystery Welder Revealed: 2012 DIGITAL POWERTIG 210EXT TIG/STICK welder
    By performance in forum Everlast Announcements, Contests and Promotions
    Replies: 46
    Last Post: 07-28-2012, 03:19 AM
  3. Welder Generator Question
    By SeanMurphy265 in forum Stick Welding (SMAW)
    Replies: 9
    Last Post: 07-02-2012, 01:29 AM
  4. Powerarc 200 with generator
    By bobwills in forum Stick Welding (SMAW)
    Replies: 6
    Last Post: 07-12-2011, 02:28 AM
  5. Running Welder on generator
    By Timberwolf in forum General Welder Questions
    Replies: 14
    Last Post: 07-01-2011, 03:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •