Share
Results 1 to 15 of 15

Thread: wire feed speed Imig200

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 05-16-2016, 10:02 PM #1
    stretch
    stretch is offline New Member
    Join Date
    Jul 2013
    Posts
    48

    Default

    Mark..Zoama..Doc ..Ram....I loaded a spool of 4043 today....Went to set the tension...It took very little tension to get it to curl on wood...Went to shut the cover & it would'nt close.....the hinge hits the black tension knob...had to really tighten it up to get it to close....Have any of you noticed or heard this?????..Also...can I run 3/64 or 1/16 in this spool gun (200n)..do I need u groove drive rolls...
    Last edited by stretch; 05-16-2016 at 10:07 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Adjusting wire feed speed - MTS 211si
    By johnsund in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 1
    Last Post: 09-07-2016, 03:48 PM
  2. wire speed accuracy?
    By mts211si in forum Multi-Process Units (TIG,Stick,Plasma/MIG,TIG,Stick Combo units)
    Replies: 20
    Last Post: 11-17-2015, 07:19 PM
  3. I-Mig 205 wire speed not high enough?
    By camboscams in forum MIG Welding (GMAW/GMAW-P/FCAW)
    Replies: 4
    Last Post: 01-21-2014, 02:41 PM
  4. Power I Mig 205 P qs ? (Size, aluminum, wire speed, flux wire, roll size, new model )
    By someguy in forum MIG Welding (GMAW/GMAW-P/FCAW)
    Replies: 26
    Last Post: 02-22-2012, 11:25 AM
  5. Mig 200 wire feed problems
    By illuvplanes in forum MIG Welding (GMAW/GMAW-P/FCAW)
    Replies: 7
    Last Post: 05-14-2011, 02:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules