Trade: CAT250D (TIG/ARC/Plasma) for I-MIG 140E

[christian]

Yes,

I have an extraneous DC welder/plasma cutter. I’ve owned it since new and it’s still new-like in its condition, even though I’ve done several cool projects with it over a period of about five years.



I upgraded to slightly better TIG and Plasma torches, moved the power switch to the front, and added a quick-disconnect to the gas line on the back. A lot of plasma consumables for the torch are included, along with an ARC stinger, ground cable, upgraded flowmeter. and several extras to go with the unit.

This is a dual-voltage unit that is undoubtedly identical to the many Lotos CAT520D units and others under other labels. They’re still being produced too, I believe. They’re Mofset inverters. This one is wired for a foot pedal, but one is not included; they’re available for about $90.

Ideally, as a trade, the I-Mig 140E must be in great condition and include the typical included accessories. I give an assigned cash value to both units (used, like new) at about $300, before shipping.

Otherwise, other similar trades may be considered.

Peace be with you all,
C. Livingstone

[christian]

Gee,

It doesn't look like the image that I've uploaded can be opened or seen here on the forum, so I'm including a link to a quick video that I've uploaded to my YouTube Channel, which shows the unit and what's included.

https://youtu.be/IwurUCM3ByU

Peace to you all,
C. Livingstone

[christian]

Gee,

Maybe someone here would consider selling their used I-Mig 140E to me instead? I could probably then sell my combo unit locally, without too much trouble I suppose.

Peace to you all,
C. Livingstone

[christian]

OK,

There doesn't seem to be much interest on this swap offer, so I think I'll withdraw it, as the shipment cost may seem to take some of the fun out of it, anyway. I may seek to sell or trade the unit locally, or just keep it for the plasma cutting ability. So, I've removed the video clip from my YouTube Channel, too.

Peace to you all,
C. Livingstone