Struggling with low current starts on 255EXT 2015

[rick9345]

some people don't/won't/can't assimilate the info at hand.
others TROLL
ON my 250EX, problems have been operator error induced RTM (then reread)

[slzboy]

I have read the RTM over and over i started welding at night but not last night but this is my first CHINESE WELDER . Operator error can not cause the arc to wonder and flutter and not start then blast like a blow torch then let off the pedal then the arc is barely there and its only on AC don't matter what the amps are the ARC SUCKS.

[everlastsupport]

I have read the RTM over and over i started welding at night but not last night but this is my first CHINESE WELDER . Operator error can not cause the arc to wonder and flutter and not start then blast like a blow torch then let off the pedal then the arc is barely there and its only on AC don't matter what the amps are the ARC SUCKS.

EDIT: Just noticed you had a separate thread already.

Maybe start a new thread and list the settings and materials, etc, like the OP. This thread it wandering and he clearly said it was bad argon (sometime when tanks get low I notice this even on what was a good tank).

Also, are you sure the other welders you have used have no Chinese parts or labor in them?