Let there be...
Just a quick bit of knocking some scraps together to put up a new LED outside light. Opted to add a brace, since I don't have anything real strong to attach to. The light output is good on these but the pattern is more directional than the light it was replacing. So raising it up should help to get back more coverage. Amazing how much light these put out with only 350 mA. Mix n match of what was laying around, .065" wall tubing and some flat bar. Set the arm up at 40° and used TIG. Welded on a 1/2" NPS locknut on the side, so I could attach conduit right to the arm and run the wires inside. Now just waiting for darkness.
Reply With Quote