Power Pro 256 stuck at 240+ AMPS

[acannell]

Some of the old posts will range from .020 (credit card range) and .045 was probably the max. But most worked in the range I posted.
Glad you are getting back running. Lucky the chip was in a socket.

Yup, thanks to Ray from a couple years ago lol

So is there anything I can do as far as improvements or upgrades? Are the newer design points better for this issue or are they beefier for some other reason? What about the 4053 circuit? Has it been changed somehow that I can do on mine?

If its just a matter of swapping a chip once every few months I guess that things are good enough. But if the points wear out too much or some other part of the circuit dies then I would like to know if I can improve it all somehow..

[everlastsupport]

Yup, thanks to Ray from a couple years ago lol

So is there anything I can do as far as improvements or upgrades? Are the newer design points better for this issue or are they beefier for some other reason? What about the 4053 circuit? Has it been changed somehow that I can do on mine?

If its just a matter of swapping a chip once every few months I guess that things are good enough. But if the points wear out too much or some other part of the circuit dies then I would like to know if I can improve it all somehow..

There was a choke mod. Do not recall what is was. I can look it up. Ray should know.