Quote Originally Posted by ChuckD View Post
Hello All,
I purchased a iMig 140 to use for simple jobs around the house. I decided to have a dedicated circuit for the welder. The breaker in the box is a 30 amp. When I plug the welder to a regular 15 amp circuit and set it up for an 1/8 plate using 0.30 wire and a 25/75 mix I can get it dialed in, but the weld is a little cold. If i keep the same settings and plug it into the dedicated 30 amp circuit it burns to hot and almost burns through. The question I have is shouldn't the welder draw only what is necessary for the settings? My gut feeling is maybe the dedicated circuit being only 6 feet from the breaker box has a increased voltage. Any advise would be appreciated.

Thanks,
Chuck
Boise, Idaho
Chuck, the unit will only pull what it needs from the panel settings. So how close to the breakers will not cause a problem. If you vary the volts, do you see a change in the power?