Some Exciting NEWS! PowerTIG 325 EXT NOW in 220V 1 and 3 phase. 480V too.

[Kempy]

Rambozo
On my 255EXT I ran my WP-20 at the limit my a time but now I think when I am going to push well over 250 Amps with the 325EXT I will put my Weldcraft CS310 on it is light and flexible and I like the triangle shape handle.

[Rambozo]

Rambozo
On my 255EXT I ran my WP-20 at the limit my a time but now I think when I am going to push well over 250 Amps with the 325EXT I will put my Weldcraft CS310 on it is light and flexible and I like the triangle shape handle.

That seems like a perfect match. Are you going with the switch handle? I'm not sure I would like it that big, but they also have a small handle, so I could swap it out.

[Kempy]

That seems like a perfect match. Are you going with the switch handle? I'm not sure I would like it that big, but they also have a small handle, so I could swap it out.

I am going to order the handle with the potentiometer built in for both torches you can just buy the handle and put you old hardware in. I have been using the linear potentiometer for my years now 90% of the work I do is standing up or working inside something and the foot control is very hard to deal with.