200dx loosing arc during weld on ac

[jeffcw30]

Mark thanks for your time. If its not a high frequency problem I'm OK with that, but I tried it with the foot pedal and torch switch and it still happens. I used it for an hour or so every day. I will admit I don't know how the electronics work inside the welder so what could it be? I definitely have a problem just need to know where to go from here? If I can get this fixed life will be good, thanks again

mark where did you go???

[Rambozo]

mark where did you go???

Your best bet might be to call Ray in the repair dept., to see if there are any other field checks you can make or if the machine needs to be sent in for repair. Sometimes it's nothing more than a connector that came loose in transit.