Power Plasma 50 MVP

[frans]

Frans what would you like to know?

Hi, just wanted to know how good is the 110 household 20amp power in running the cutter. Can i reasonably expect to be able to cut 1/8" material slowly? Or is the 110 really best for sheet metal?
Thanks
Frans
P.s. Thanks for the welcome

[performance]

It'll cut 1/8 just fine...IF you use the smaller consumables that are offered (which we do not specifically carry but are available at a multitude of places). The S-25 consumables would probably work best in the S-45 torch and believe they are interchangeable.

[frans]

Thx. I will check it out

[everlastsupport]

Yes, the S25 S35 and S45 consumables are interchangeable.