250DX AC Aluminum Weld Issue

[dmost]

You want to set up about 30% on balance and 120 or so on frequency. If you watched Jody's videos with the 250EX you can see the knobs are about 2 o'clock and 10 o'clock left to right. Also, if you run 7 LPM you should be just fine.

The information has been covered many times here on the forum and like Mark said it's covered in the manual. But that should get you straight. Post up some new shots so we can see.

Well as Mark said I read the MANUAL and set the balance to 30%. No real big change in the weld. Still getting a lot of impurities and almost like a black foam covering while I'm trying to weld. I also tried it from 0-40% after the initial 30% didn't do much. I will include images below. Also my torch decided it didn't want to flew anymore and split at the neck. I have only had this thing for a few months. See the images below for settings and torch pic.