A special thanks to Alex and Everlast for helping me make the right decision on my PowerPro 205 welder purchase. This is not my first welder but by far it is the best. So far it's capabilities far exceed mine but hopefully not for long. The entire process of this purchase was painless. The lessons I've learned watching Jody's videos are priceless, that and being steered in the direction of Everlast helped everything fall into place. When it came a different tig torch was supposed to be shipped with it but I received the 26 series and told Alex it was like welding with a fire hose, not sure he found any humor in that but I do have the right one now. Just a couple things I will need to address, one being the air gauge on the panel is the hard to read white faced one. The picture in the ad shows a black, very easy to read gauge. Not a big deal once you know what number the needles aiming at. Also the control panel where the screws fasten it down, the material is bubbling up possibly from over tightening because one of the screws is stripped. You can push the bubbles out but they come back after awhile. They spread out from the screws almost an inch. Maybe some day if the other gauge is available I'll replace it and see if there's a cure for the covering being loose. Listen to me, first I praise it then I pick at it. Anyway I am very happy with it and just want to say Thanks again, Danny