Anti-roll bar link mounts

[its_34]

Just a hole saw and then dressed them with a sanding roll. I put a 7/8" hole in the center of a 1x2 piece then cut it in half to make two parts.

Turned out real nice, well done. Can I ask, what are you using to cut the half circles out of the end in picture 2 of 4? Those are some clean cuts.

[Jason]

Nice, I like the adjustability that they have and that will have some positive effects. Should be nice and stiff without any rubber bushings too. I changed my factory rubber bushings to poly inserts.

[its_34]

Preload is bad, so adjustability is a must. The purpose of this was actually to relocate the mounts inboard and reduce the effective rate of the bar.