TIG torch replacement parts

[Mr120]

Waitwhat? So, in theory, I could easily add a switch to cut the pedal out of circuit and not have to constantly unscrew it when I switch from TIG to stick? Pinout diagram please!

EDIT: Well, it should be trivial to find the correct two pins with a jumper wire, but if a pinout is available, I'll take it!

I found this:

http://www.everlastgenerators.com/fo...-pedal-pinouts

Hope it helps.

[joshuab]

I found this:
http://www.everlastgenerators.com/fo...-pedal-pinouts
Hope it helps.

Thanks very much.