I just looked at it again and noticed the torch crash and material drag at the end.
I assume that is because the voltage gets out of range because the cut is finished.
Senior Member
I just looked at it again and noticed the torch crash and material drag at the end.
I assume that is because the voltage gets out of range because the cut is finished.
Everlast 200DX
Everlast PT185
Shoptask 3-in-1 (not currently in my garage, but I own it...)
Any day on a motorcycle like this that ends just needing parts and labor is a good day.
4.82, 158.67mph 1/8th mile 7.350, 200.35mph 1/4 mile
Posting Permissions
Reply With Quote