Stocking Stuffer TIG CONSUMABLE KIT

[Tanh]

Clear pyrex is only for the push on style lens. A standard gas lens is threaded so I don't believe that's an option at this time.

So far I've only seen the pyrex with the CK gas saver kit. Is there another option from another company? Don't want to hijack the thread but since Duncan is local, it'll be a better option than ordering online. I mentioned in another thread that I was going for the gas saver look for the wp17v torch that came with the welder.

[zoama]

So far I've only seen the pyrex with the CK gas saver kit. Is there another option from another company? Don't want to hijack the thread but since Duncan is local, it'll be a better option than ordering online. I mentioned in another thread that I was going for the gas saver look for the wp17v torch that came with the welder.

Not that I'm aware of.

[JimMinKent]

CK does make slip-on ceramic (alumina) cups for their Gas Saver front end. I've got a few sizes #4, #6, etc. for the 2-Series torch, plus a couple different lengths of pyrex, and a set for my gas-cooled torches.

See them here: http://www.ckworldwide.com/gas_saver.pdf

Jim

[willida]

I got my gas lens kit for my CK 130 amp toch.
Thanks Jeane