So I started messing around a little today and decided to make an intake manifold for a friends car. Didn't get any welding in because I am designing/building as I go and its going slow. I had to do the main piece twice because I didn't make my measurements correctly for the bends in the break the first time. When I did the first one it was all twisted and wouldn't have lined up, lesson learned.
Pics so far:
Click image for larger version.  Name: 1.jpg  Views: 725  Size: 87.2 KB  ID: 8726
The flange on the bottom is one I had CNC'd in a batch for when I make ITB manifolds, so I already had it.
Click image for larger version.  Name: 2.jpg  Views: 579  Size: 57.7 KB  ID: 8727
What I am going to do next is cut out a plate for one end and then machine out a 3/8 piece of AL plate for the other end cap where the throttle body will bolt to. Once that is done I will close up the big gap with a piece of sheet and add the runners and then the flange.
Not much so far for 4 hours of work, lol. If I didnt mess up the first one I would have been better on time.