Project 1 from CGCINC. Category: Welding Cart

[agent4573]

Is there a method to designing a plasma cutting table? I thought it was kind of a "consumable" while cutting so I never thought about the design.

Also, how much does this beast weigh?

[CGCINC]

Is there a method to designing a plasma cutting table? I thought it was kind of a "consumable" while cutting so I never thought about the design.

Also, how much does this beast weigh?

No method, I just go overboard with things sometimes. I made the grate out of 1 1/2" flat stock so I'm thinking it will "last" for awhile.....Might look like it's been through a war though

As far as weight?!? I have no clue. The bandsaw with the cast base is heavy. I would guess maybe 100-125lbs. total???? maybe a little more....?

[CGCINC]

Got it wired up today.
It's basically ready to go! I need to order some sheet for the bottom shelf but it's good for now

[zedron]

I must say that this is coming along very nicely. I wish I had more room in my garage so I could have dedicated carts/tables like this. Everything I get has to be able to fold up.

[redbeard]

Probably not the most functional though..... lol

I dunno about that, I really like the idea of using the diamond areas for drilling. I may have to incorporate something similar into my woodworking bench.

Everything I get has to be able to fold up.

Post up your folding stuff if you make any, I'm in the same boat and could really use some design ideas.

[CGCINC]

DONE!!!