NEW 2013 EVERLAST PowerTig 255 EXT AC/DC DIGITAL TIG WELDER

[performance]

I'm not sure what the problem is for Kempy. I checked. It's there. I replaced the video link.

[Rambozo]

First the music was blasting after the feature list now its hard to tell it's there at all. I guess the gods of YouTube are not smiling at you today. I think the effect you setup was to have it as background for voice over, then swell during the feature crawl, and back down to background for the rest. I'll take this version over the first.
Glad to see this machine "live". I have one question, on the gas preflow, when you first accessed it, it looked like it was set at .5 but as you turned the knob, it went so fast that it looked like it was only going in full second increments. If you turn the knob slower can you set a time smaller than 1 second? I think the .5 is about right for most things. It appears that the faster you turn the knob the coarser the adjustment, is that the case? Very cool feature if it is.

[performance]

I reposted a new link. The new video isn't bad. Watched it. I do know it sounds differently on different speaker systems. My laptop computer has sorry speakers, and I can hear it pleasantly but not loud, but through my stereo headphones (which aren't top of the line) it is blended nicely with a little more music volume.

It adjusts in .1 increments up to 10, then larger whole numbers (no need for .1 seconds really after 10 seconds) or if you push in on the knob, larger increments, by 10 usually.

[JimMinKent]

Mark, That's really a good video, well done!

I'm looking forward to the next clips, and of course, seeing mine sitting in my shop

Thanks for your efforts to put these out.

Now ready more than ever in Kent,

Jim

[Jason]

On my laptop, the first was way loud and the second is pretty quiet. I can hardly hear the music at all and the voice is high. Either way, the second video is much better than the first.

[performance]

Part 2.