NEW 2013 EVERLAST PowerTig 255 EXT AC/DC DIGITAL TIG WELDER

[JimMinKent]

Thanks Mark,

If it uses quick taps, that's fine, it's pressing and holding for x number of seconds that I am not a fan of.

My thinking on the knob is, since it only has one,and it is nearly the entire interface, let's make it a nice one Even the current 250EX amp knob is a bit nicer than the one shown in the photos of the 255. After all, this is your top-level entry in the US, right? Thanks for whatever you can do for us.

Jim

[performance]

I don't have anything to do with that at this point. That detail would be for Duncan. He has his hands on the digital units in the factory. I have no idea. It will be whatever is available to fit the encoder that is used. They don't fit the same. To special make one would involve a lot of expense and planning.

It'll likely be this knob or a cut down version of it:

[Oleg]

UPDATE:


http://www.everlastgenerators.com/fo...werTig-255-EXT