Qustion About MotorGuard Air Filters

[Gerry]

Went to Lowes after work today, got several couplers & ends, 50 amp plug & 1/4" nipple, only thing left is the coiled hose. Should have got that at the Tractor store when I was there. I can get that later, all I need now is the Motorguard and the cutter.

[Gerry]

I got the Motor Guard Filter, wish now I would have got the M60 with the 1/2" ports which are on the top of the filter. 1/2 to 1/4 bushing and I could have screwed the water/oil separator into the filter and saved some brass fittings and away to mount the separator..
The cutter will be here tomorrow, I'll have to wait and see what's, what's then.

[zoama]

I got the Motor Guard Filter, wish now I would have got the M60 with the 1/2" ports which are on the top of the filter. 1/2 to 1/4 bushing and I could have screwed the water/oil separator into the filter and saved some brass fittings and away to mount the separator..
The cutter will be here tomorrow, I'll have to wait and see what's, what's then.

What's the fitting size on the one you got ?

[Gerry]

1/4" on the bottom of the filter

[zoama]

1/4" on the bottom of the filter

I have the m60 version and assumed that all of them were made the same way. You could exchange it for the m60 kit if you can wait another week.

[Gerry]

I'm going to keep it, it will take just a little more brass to plumb things up the way I want.
Did get the cutter to day, very nice & heavy unit. I need to make a bracket to mount the small separator that came with it, a couple more 3/8 hose barbs and another piece of air hose. if the hose that came with it was about another foot long, I'd be just about set.
I might get a chance to try it out this weekend after work.