Project 2 from Rambozo. Category: General Welding Repair
Just a few repairs/modifications to a couple of trailers.
This first one was a tilt bed that was made for a soil compactor, which I am repurposing to hold a golf cart utility vehicle. The center of gravity was not right to get the bed to drop unless the cart could drive on a little further. So I cut off the old stop, cut a couple of notches and added some wheel stops to let the cart come forward a few inches. Most all the welding was 6011 underneath and 7018 on the clean parts. I also welded on some brackets to attach some ratchet straps to tie down the cart, and a small hand winch to load the cart if it won't run.
To be continued...
Reply With Quote