I actually did this project on Sept 19, the second day I had my Supercut 50P.

I used my PA140ST in TIG mode and SuperCut 50P. I was using a 3/32 2% thoriated with a #5 cap. Amperage was 140. Filler rod was a 1/16 ER70S2. The metal used was 6x4x.250 brick lentil.

I used a piece of aluminum as a guide to cut the lentil. Amps were at 50 and pressure was approx 60. Cut like butter. I then changed caps for one without the guide and freehand cut at a 45 (just because it was thicker.... ) It measured .58 - .59 thick. I then used the plasma cutter to mark the holes and then drilled them on the press. All this drag tipping at 50 amps took a tole on the consumables... I then set the 140 at max and tacked the plate on. Once everthing looked good, welded top and bottom.

Click image for larger version.  Name: lentle.jpg  Views: 488  Size: 126.2 KB  ID: 8188Click image for larger version.  Name: guide.jpg  Views: 507  Size: 137.7 KB  ID: 8187Click image for larger version.  Name: freehand.jpg  Views: 486  Size: 96.3 KB  ID: 8186Click image for larger version.  Name: thickness.jpg  Views: 505  Size: 107.0 KB  ID: 8184Click image for larger version.  Name: nozzle.jpg  Views: 484  Size: 127.3 KB  ID: 8189Click image for larger version.  Name: bracket.jpg  Views: 471  Size: 147.1 KB  ID: 8185Click image for larger version.  Name: rough-edge.jpg  Views: 529  Size: 142.1 KB  ID: 8190Click image for larger version.  Name: rusty-weld.jpg  Views: 518  Size: 145.9 KB  ID: 8191

I haven't had time to paint the bracket yet so it is already starting to rust.

This was a easy project and didn't take long at all thanks to the SuperCut 50P. I am very happy with the results.