Well I fired up the plasma cutter today and all seems well. It did act up one time but I am not sure if it was something I did or not. I had used it to cut a piece of 6x4x.250 angle (at 50 amps) and left it sitting for 5 - 10 min while I ground the rough edges off and clamped it in place. I then picked up the torch and hit put the tip against the metal and pulled the trigger.... nothing. On the unit, the little red light was on so I turned it off and waited a min and turned it back on. Worked fine. I don't know if I over did it cutting the angle... wouldn't think so as the total cut time was probably 5-6 min total with a minute or more gap between the cuts ( 3 cuts total).

All in all I am very happy with it. Cut some 3/8 bolts off in seconds.... Now just need to get the regulator replaced.

THANKS EVERLAST TEAM!! You guys rock!!!