That pump has a built in relief valve. You just need to adjust it to what you want.Originally Posted by welderdude
Senior Member
That pump has a built in relief valve. You just need to adjust it to what you want.
Long arc, short arc, heliarc and in-the-dark!
Member
@ Rodsmachineshop: Thats a good point. I might just use some CLR to flush it out. I have flushed it with water both ways though. I might even get an in-line filter to put right before the torch if I can find the right one.
@ Rambozo: That is true. Hopefully I can adjust it down to 50 or so psi. It will keep it even simpler.
Everlast lx225
Hobart Handler 210 with spool gun
Hobart Stickmate LX
Thermal Arc 400GMS
40 amp Northern Tools plasma torch
130 chicago electric tig welder
90 amp chicago electric flux mig
10"-22" Grizzly lathe
15"-5.5" Grizzly vertical end mill
In need of nice TIG machine. drooling over PowerTig 250ex
Senior Member
i have been using for years best to clean cooling systems cascade dishwashing detergent for cleaning radiators and heater cores
EVERLAST 250 EX , EVERLAST I-MIG 205 , EVERLAST spool gun NOW have 2 EVERLAST POWER PLASMA 50 plasma cutter's , LINCOLN 175HD MIG WELDER , VICTOR TORCH SET and many more tools to many to list
Senior Member
One of these will give you an extra bit of protection. Especially nice if your water cooler doesn't power on with your welder.
http://www.ckworldwide.com/fuse_block.htm
Next torch I get I'll be using one for sure.
Long arc, short arc, heliarc and in-the-dark!
Posting Permissions
Reply With Quote