Source for weldable hinges?

[DaveO]

Any hardware store / Home Deep / Lowes (or Walmart, or even Albertson's grocery for that matter) would have some manner of steel hinges. Are you looking for something specific, maybe something without the rust-proofing?

[undercut]

Any hardware store / Home Deep / Lowes (or Walmart, or even Albertson's grocery for that matter) would have some manner of steel hinges. Are you looking for something specific, maybe something without the rust-proofing?

Sorry, DaveO, I was writing my reply to sportbike and got distracted for a bit and didn't see your reply by the time I submitted. I thought I saw some when searching Harbor Freight, Lowes or Home Depot but when I went back, I couldn't find them. I'm looking for simple hinges that don't cost much and definitely don't have any kind of coating. Because the enclosure will be made of material no wider than 3/4", I don't want huge flanges on them.

I'm currently looking at:

http://www.mcmaster.com/#weld-on-hinges/=hgpls7

from the source that sportbike pointed me to. I'm a newbie welder so the skinny profile of these have me a bit concerned. I'd be more comfortable welding a tab as opposed to welding so close to the hinge pin - at least until I get some experience and understand my limitations a bit better (which I hope this project will do). I haven't looked at all of the products from this supplier but most of them have tabs larger than 1" so I'll keep looking for now. If I need to, I guess I can weld then grind the overhang off.

[Rodsmachineshop]

weld on bullet hinges are nice http://www.mcmaster.com/#bullet-hinges/=hgprx3

[undercut]

weld on bullet hinges are nice http://www.mcmaster.com/#bullet-hinges/=hgprx3

I've got some preliminary quotes on steel tubing. 3/4 SQ tube, 3/32 inch thick. I like those 29/64" bullet hinges. Hope I can weld those on and not screw up the alignment of the pins ....

[zoama]

All the weld on hinges I've used, the pin fits pretty loose. I got my last six from grainger http://www.grainger.com/Grainger/MAR...inge-4PPU5?Pid

[undercut]

All the weld on hinges I've used, the pin fits pretty loose. I got my last six from grainger http://www.grainger.com/Grainger/MAR...inge-4PPU5?Pid

Those are pretty nice. Brass pins with a grease fittings. For my project, I'll go with some plain jane versions. Good to know they will be a bit loose. Need them to be gentle on me in case I make some mistakes ....