Project 1 from KSmith. Category: Welding Cart

[KSmith]

All loaded up the cart maneuvers very nice. The top shelf is saved for a future 200DX, finger's crossed. Some of the photos make it seem the cart is tilted, but it is just the effect of the wide angle lense. The cart is square in all dimensions.



thank you for looking.

[everlastsupport]

Looks good. Wish I had used bigger tires. I know my 5" rubber caster type are too small for shellrock. Could be all the weight on there too .

Make sure you get some chains for the bottle, they do not go bad or stretch on you down the road..

[KSmith]

The bungees are temporary for now.

Harbor Freight had a special on the 10" pneumatic tires a while back, for $3.99 each, and with my cart in mind, I stocked up. They can be bought now for the lofty sum of 4.99. http://www.harborfreight.com/10-inch...ire-30900.html

I bought 5/8" rod for the axles, cut and drilled for cotter pins.

[Rodsmachineshop]

good place to buy casters and tires and other stuff https://www.surpluscenter.com/wheels.asp?catname=wheels they have them here for 2.99 they have all types of casters and wheels think these wheels look cool since have brass centers

[KSmith]

guess I'd need fancy mud flaps with those brass wheels.

great source. Thanks Rod.

[Brian Ski]

Nice job!!! I looked at a cheap cart at Harbor... Yea... It is a really cheap cart... And small. So it looks like you have a really nice size to copy...

I know you were going to put chains on the tank to hold it, but I am thinking of a cut out or something to hold the bottom of the tank so it does not slide around. Around here I have to drag it over a busted up old drive so anything I drag out gets a lot of bouncing. C'mon concrete drive!!!! Maybe I will get to a couple of pours this year.... Anyone want to help???