Senior Member
Project 1 from CGCINC. Category: MIG Welding Cart
I ordered and recieved my I-MIG 200 so I used it to build a welding cart.
I constructed this out of 1" square tubing, 16g.
The tank is an 80cf I bought cheap and is a good size for what I will be using this for.
The rear no flat tires are 10" in dia. and the front swivel castors are 5". I wanted it to roll good on rough terrain or rock driveways so I went large on the wheels.
I wanted to have rounded corners but I don't have a way to bend things....
This is what I did to round them......
PowerTig 250EX
Power I-MIG 200
Power Plasma 50
It's what you learn, After you know it all, that counts!
Senior Member
PowerTig 250EX
Power I-MIG 200
Power Plasma 50
It's what you learn, After you know it all, that counts!
Senior Member
Last edited by CGCINC; 04-11-2012 at 12:49 AM.
PowerTig 250EX
Power I-MIG 200
Power Plasma 50
It's what you learn, After you know it all, that counts!
New Member
Very nice cart, very well thought out.
Everlast PowerTig 225 LX
Miller Spectrum 375
M-Tech Model 3 Tube Bender
JD2 Notch Master Tube Notcher
Light Racing Dimple Dies
Super Moderator
Very nice work. How long did this take to build ?
Links to my welding projects > : Spray Arc with the 250p : Coldsaw Stand : Welding Cart : Heavy Duty Rolling Shelf : Taller Bandsaw
2013 250EX : SSC Pedal : I-MIG 250P 20' Profax gun : Power Plasma 60 p80 torch : 3M Speedglas 9100XX : Evolution Rage 3 DB cold saw
Member
That's one of the best carts I've seen in a while and just curious how much the material cost were?
Member
As with all your builds very impressive, nice touches the holder for grinder and holder for cables. I like the way you built the frame with rounded corners and where front wheels are mounted. Nice job.
Bill
Posting Permissions
Reply With Quote
