Noob TIG welds

[posixPilot]

In traditional Everlast forums fashion, I submit to the group my first TIG welds from my PPro 256. Don't laugh too hard .



These were done on 1/16" sheet steel with a 1/16" 2% ceriated, DCEP at 50amps. The steel, only just yesterday, was edging a flower bed, so I cleaned it up as best I could and decided to practice on it. I did notice what I believed to be contamination in the puddle, which almost looked like rust spots, floating up from the leading edge. Anyways, tell me what you think. Constructive criticism is always welcome.

Thanks
Mike