Project #2 Welding Cart for 225LX, TIG Cooler, and eventually a Plasma Cutter

[sw2x]

PP80 will fit. I checked the dimensions before I built the cart. So when I win the PP80 in the this competition I can slide it right in and go to town.

[sw2x]

Getting closer....

Got the wheels mounted. Ran into a ground clearance issue when using these wheels and wanted to keep the frame as low as possible without getting hung up on things so I had to raise the front wheel mounts quite a bit. I haven't gusseted the wheel mounts yet or done and finish welding and grinding. But I think it's coming along pretty good.







All that's left is welding on a handle, hooks, the sides, and finish welding and grinding. To mount the Harbor Freight rear wheels I grabbed a 5/8" x 36" steel rod from Home Depot for $10 and welded some thick washers on for stops, and drilled a hole through it and used another washer and cotter pin to hold the wheels on. Works great. It rolls like like a CHAMP.