Quote Originally Posted by zoama585 View Post
Are you getting an arc between the points ? Your gap may need to be a little over .030 .... As for the amp drop, is the switch set to 2t or 4t ?
2t. I just experimented and the amp drop I think has to do with Start and End Amps. For Example if I have the machine set for 80 amps, then I moved Start and End Amps to roughly 80. I still hear the machine cycle at the end, but it stays around the 80 amps I have dialed up instead of dropping to 20 amps (which is where I had the start amps dialed in at the beginning). I will check the points to see if i get an arc between the points.

Any other suggestions?

Thanks