Still have this?
Member
Still have this?
Senior Member
I'm sorry, I should have changed this to sold. I sold it to use a 50%off coupon and purchased a 225lx. Slowly moving up the ladder.
Lincoln Eagle Engine Drive
Everlast MTS 250
Everlast Power Tig 225lx
HTP Mig 2400
Everlast Power Plasma 60C --> Just need to finish my CNC Plasma Table!
Miller Spectrum 375 Extreme Plasma cutter
Victor cutting torch
HF 20 Ton Shop Press
HF 4x6 Band Saw
HF Air Compressor
Northern Tool Drill Press
www.murphywelding.com
Member
Gotcha--thanks for responding to let me know. And congrats on the upgrade!Originally Posted by SeanMurphy265
Have you had good luck with all of the everlast equipment?
New to welding!
Lots of Snap-On tools
In need of more toys
Senior Member
I've only had two issues and both were taken care off. I ordered one of the first PowerArc140st's last summer and it had an issue blowing fuses from day one. After a day or two she let go and Everlast sent me another machine with no problems.
The second problem (not Everlast fault) was a plasma torch switch on my Super Cut 50. Everlast sent me a new torch and my problems were taken care of.
Only two issues I have had an was taken care of both times.
Lincoln Eagle Engine Drive
Everlast MTS 250
Everlast Power Tig 225lx
HTP Mig 2400
Everlast Power Plasma 60C --> Just need to finish my CNC Plasma Table!
Miller Spectrum 375 Extreme Plasma cutter
Victor cutting torch
HF 20 Ton Shop Press
HF 4x6 Band Saw
HF Air Compressor
Northern Tool Drill Press
www.murphywelding.com
Posting Permissions
Reply With Quote