Results 1 to 5 of 5

Thread: 205 issues

  1. Default 205 issues

    Power Ultra 205

    It is possibly operator failure, but I cannot strike an arc with the arc attachment. The plasma seems to work fine. I have not tried the tig because I don't have an argon tank yet.

    I had plasma/tig switch set to tig, tried switching from local to remote. I took both ends of arc cord apart to make sure connections were tight. Ground cord must be ok because plasma worked.
    Last edited by roadymi; 09-20-2009 at 08:03 PM. Reason: add info

  2. #2


    John, calling you now. Thanks for the PM and number.
    Mike R.
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

  3. Default Great Customer Service!!!

    Well, it was operator failure. Mike called me right back and we had it working in just a couple of minutes. Turns out I didn't realize the switch for tig/plasma/arc was a 3 position switch and I wasn't getting it switched into the arc position.

    Again great customer service on a Sunday no less. Thanks Mike!!!

  4. #4


    It's great being able to get technical assistance on a Sunday! Great job Mike.

  5. #5


    We aim to please.

    You would be surprised how many people call on the weekend. Normally while I am riding of course and my son hates it when I pull over for a tech call.
    You should see he face when he hears "OK, that knob controls the...". He knows it will be a few minutes.

    Glad you guys purchased from Everlast and we want to make it the best experience we can.
    Mike R.
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

Similar Threads

  1. 225 lx issues
    By SeanMurphy265 in forum TIG Welding (GTAW/GTAW-P)
    Replies: 14
    Last Post: 04-28-2016, 01:50 AM
  2. Am I having gas issues?
    By Rodzilla in forum TIG Welding (GTAW/GTAW-P)
    Replies: 8
    Last Post: 12-04-2015, 04:19 PM
  3. 250 EX issues
    By Skeeter in forum TIG Welding (GTAW/GTAW-P)
    Replies: 16
    Last Post: 07-21-2015, 02:50 AM
  4. On/off switch issues
    By broberts5 in forum TIG Welding (GTAW/GTAW-P)
    Replies: 1
    Last Post: 08-16-2013, 10:53 PM
  5. PP50 arc issues
    By millermatic in forum Everlast Plasma Cutters (PAC)
    Replies: 7
    Last Post: 09-29-2012, 10:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts