eyspy 
If I weld on galvanized I try to grind the area I'm welding. I try to get rid of the galvanizing or at least as much as possible. 6010 would probably work pretty good since that's considered the dirty, greasy, painted steel rod.
Senior Member
If I weld on galvanized I try to grind the area I'm welding. I try to get rid of the galvanizing or at least as much as possible. 6010 would probably work pretty good since that's considered the dirty, greasy, painted steel rod.
Lincoln Eagle Engine Drive
Everlast MTS 250
Everlast Power Tig 225lx
HTP Mig 2400
Everlast Power Plasma 60C --> Just need to finish my CNC Plasma Table!
Miller Spectrum 375 Extreme Plasma cutter
Victor cutting torch
HF 20 Ton Shop Press
HF 4x6 Band Saw
HF Air Compressor
Northern Tool Drill Press
www.murphywelding.com
Senior Member
In case it becomes useful information, in another post Eyspy said he has a PowerArc 200. The max recommended rod size for this machine is 3/16". As a reminder, 3/16" converts to metric by multiplying by 25.4:
3/16" x 25.4 = 4.76mm
This is assuming the technical specs of the Australian machine are identical- I seem to recall there were some minor differences between machines sold here and machines in Australia.
DaveO
Oxweld oxy acet gear
IMIG 200
PowerTIG 210 EXT... Amazing!
Posting Permissions
