Quote Originally Posted by Velocity View Post
18" filler is alot easier to handle then 36" and would assist "newbie" welders. Some people have it in their heads that you waste rod, but what is an extra inch?

Good idea on the "set up" packs though. What tungstens are u going to supply?



We presently stock 2% Ceriated 2% lanthanated and 2% Thoriated from 1.6mm up to 3.2mm
I was thinking of having each type packaged in
2x 1.6mm
3x 2.0mm
3 x 2.4mm
2 x 3.2mm
I do not think we need to carry any other types as this covers the majority
of most peoples needs.
And i was thinking of doing the same with the Filler Rod with
2 grades of Aluminum and 2 of Stainless ( except it would make up 2 lbs of rod ) or something along those lines.
Had some customers in on Friday to try and buy and a couple wanted stainless steel filler that i could not supply.
Praxair is right next door, so you would have thought it would be a no brainer and very simple to pick up what you need. The have a minimum 10lb order for sales so i had to send a couple of customers elsewhere as they did not want to get this much in one size.