Hi,
I have been a hobby welder since high school. Just bought a everlast 140 st, My Powcon 300 SM will not turn down below 30amps or so, too much power doing tig on small parts. Plus the idea of a small welder that I can plug in to 120 was just to appealing to pass up. Ran a few tests with 6013 1/8 and also on one of my current 17 series touches. So far so good. Got a laugh from the singing it does with an open circuit, quiets right down under load. I like the display showing amp settings. I haven't checked with amp meter how close it is to measured amps.
Cheers for now
Tom