I have just gotten around to learning to use the foot pedal on my ultra 205. I plug the pedal in, set amperage knob all the way down (left) and set the rocker switch to Remote. Even at the most minimal depression of the pedal the torch is full heat... like probably 200 amps. which just fries the 14 gauge I am trying to weld. I can weld this stuff just fine if I use a 10 or 15 amp panel setting, which produces a much smaller flame than the minimum I can get the pedal to give me.

What am I doing wrong?
How do I get the pedal to give me very low amps?