Project 1, Third Hand, from Tritium

[Tritium]

I made a very quick and dirty "Third Hand" from an old "Lawn Dart" and a piece of 16 gauge steel.

Attachment 2407Attachment 2408Attachment 2409

Process was simple.

Step 1: Bend the "dart" tip at 90 degrees in a vice.

Step 2: Drill a small hole in the center of a 1" by 3" piece of 16 gauge steel.

Step 3" Lawn Dart is already threaded so screw on a nut, pass the threaded end through the hole in the 16 gauge plate and secure with another nut.

Project completed 15 minutes total time. Materials used 1 old lawn dart, 1 piece of 16 ga steel 1" by 3".