Results 1 to 2 of 2

Thread: A Nova Scotia customers review - SuperCut50

  1. #1

    Default A Nova Scotia customers review - SuperCut50

    Mike R.
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

  2. #2

    Default Actual post

    In the Box;

    Plasma cutter with integrated air regulator

    Torch assembly

    Grounding cable assembly

    Water trap/air filter

    Necessary brackets and hoses and fittings to assemble

    230v Plug

    5 spare consumables, 1 spare diffuser and some extra fuses.

    Instruction Manual

    Almost ready to go out of the box, I just had to hook up water trap, plug and connect the torch to the front panel. The plug supplied is an RV plug, different than what I use in my shop so I purchased a standard welder receptacle at the hardware store. The front panel easily connects the air and trigger connections for the torch and a quick “push n twist” for the ground cable. Even weighing in at 45lbs this is still going to be quite portable where the cables can be removed so easily to avoid damage. The torch is very agronomic and compatible with a few other brands such as Speedway and HTP so consumables should be more accessible.

    There is a switch for “Self Test” for air adjustment without having to engage the torch.

    For comparison my previous plasma cutter was an older Cebora Pocket 30, 30 amp, no adjustable voltage and capable of cutting 3/16 up to 3/8 severance.

    I did 3 cuts starting from Left to right, 3/16 was no problem, with a straight edge I was able to wiz through 2 inch's of it in about 2 seconds. The second cut was on 5/16 which I had to slow down to make a clean cut, took about 5 seconds. On 1 1/4 I had difficulty in the middle but this machine is only rated to cut a maximum of 1" but I had to try.

    Overall I am happy with its performance and it does out perform my previous unit, of course my question is will it stand the test of time? So far I have used this for maybe an hour of total cutting time and no signs of wear are showing on the tips.
    Mike R.
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

Similar Threads

  1. NEED some Working pictures of customers
    By performance in forum Everlast Announcements, Contests and Promotions
    Replies: 36
    Last Post: 10-03-2013, 01:30 PM
  2. Review of my new I-MIG 200.
    By 225 in forum MIG Welding (GMAW/GMAW-P/FCAW)
    Replies: 9
    Last Post: 03-10-2013, 07:42 PM
  3. Powerarc 140 review
    By atatro in forum Stick Welding (SMAW)
    Replies: 40
    Last Post: 06-13-2012, 01:12 PM
  4. Super Cut 50 Review
    By WAYNESWORLD in forum Everlast Plasma Cutters (PAC)
    Replies: 17
    Last Post: 12-28-2009, 03:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts