I-mig 200

[kenwhite]

deleted...

[performance]

The unit should, or at least that is what is supposed to happen.

[performance]

Ken there should be some way to adjust it. I've not had any problems with closure on those units. But I haven't seen everyone either. Which part exactly is giving issues? Is it the snaps?

[performance]

Understood. Don't open too much or the little spring loaded balls won't snap into place.

[performance]

Be sure that the white is used as the common on the 110V. It does matter. I thought we had mentioned this several times on here. But I will repeat it: DON'T USE THE PLUG SUPPLIED WITH THE UNIT IF YOU RECEIVE ONE WITH YOURS.

[ogorir]

I had/have the same issue. I bought an I-MIG200 in april that shipped with the new trafimet gun and no regulator. I sent a few emails to cust. service and got nothing back but the automated replies, so I'm trying here now.

I have to say I'm pretty disappointed with the trafimet gun. it uses the same consumables as the harbor freight mig welders. the nozzle is a pain in the ### to remove because the spring retainer bites into the copper lining. thing welds like a champ, though. smoothest MIG beads I've ever seen.